Music systems have become an essential one for us as it helps us to relax from our pressures. Loudness and the clarity of the music talk a lot about the quality of the system we use. To increase the loudness and clarity of the music we use amplifiers. After reading this article you will know how to connect an original car stereo to an amp.
The works requires the following tools to proceed. It will require screw drivers of the Philips company, a drill, a panel tool, a kit which contains amplifier wirings , groomets and spacers made of rubber. It will also require the use of wires and harness adapter.
First of all the negative cable has to be disconnected from the battery. This cable gives the connection between the negative lead and the vehicle. The clamp of the cable is removed using a screw driver .It is left undisturbed until the process is completed.
With the help of a Philips screw driver the positive lead cable is connected to the ring terminal of the amplifier. Before being connected to the amplifier the fuse is removed from the ring terminal. A hole is drilled into the engine compartment's firewall. Through this hole only the power is supplied to the amplifier location from the car battery. The wiring protection is important and for that one must use a rubber grommet for covering that hole.
Once again with the help of a screw driver, the positive terminal of the battery is connected to the ring terminal of the amplifier. Before making this connection make sure that the fuse wire is removed from the ring terminal.
Using the hand, wiring groups are disconnected. The plastic binders are used to grab all the groups. The wiring harness adapter is connected to the groups. Clear indications will be given on how to connect them. Now a connection is established between the stereo of the car and the adapter. The signal cable and turn on lead is connected to the harness adapter. The panels are removed by using a trim panel. The wires are laid under the carpet. The power supply is run from the batteries to the amplifiers.
The wires are connected to the speakers from the amplifier. This is done with the help of the instructions given in the manual of the car. The stereo is placed on the dashboard of the car. The fuse is inserted in the socket. The negative cable of the battery is reconnected. The clamps need to be tightened properly with the help of a screw driver. This clamps need to be in proper position which will avoid it to be loosened or moved by using one's hand.
In the next step two more wires are connected to the adapter those includes a signal cable and another is the turn on lead. From this the cables are brought to the location of the amplifier. Then connect the speakers and give power supply to the amplifier. And in the end connect the fuse. So one must always know how to connect an original car stereo to an amp.
Looking to find the best deal on Auto Hifi, then visit www.powernetshop.at to find the best advice on Car audio for you.
